![]() ![]() ![]() The main shaft and the clutch pack is unsupported at the end. The problem is, is with the main shaft and the fact that the clutch pack is mounted so far away from the shaft support which is the main shaft ball bearing. The six speed transmission uses pretty much the same design as the proven 5 speed design only with an extra gear. The next sentence is not entirely accurate but will suffice for this discussion. I've also heard from very reliable sources that Baker and yes even Harley has have had trouble with their six speed transmission bearings. I have personally seen bearing damage and main shaft bending from the Rev Tech 6 speeds. There has have been numerous reports on trap door bearings and the main shaft main ball bearing going bad prematurely on six speed transmissions on all makes. Chaos Service Bulletin #26 speed transmission bearing failure. Thought I would throw it out here to hear other people thoughts on this.ĭr. While searching the Internet to learn what makes the baker 6 speed, how it is made and researching bearing failures, I ran across this article. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |